599 / Eagle Users manual
Release 1.002 – September 27, 2010
8
Part #74447
Printed in USA
RIT (22)
The receiver integrated tuning can be selected
as a secondary button function by pressing
FNC and then the MOD button. You will
notice RIT will begin to flash on the front
panel and you may now adjust the receiver in
10 Hz increments up or down frequency
using the MULTI knob. To zero out the RIT
simply press and hold the MOD button and
the display will zero out. To exit simply
press the FNC button
Multi (26)
Most features on the Eagle are directly
accessible, however, for those that are not the
MULTI KNOB is used to adjust specific
values. More about this will be addressed
within specific features throughout this
manual.
Band (21)
To change bands or toggle through the Ham
bands press the BAN button and the next
higher Amateur band will appear. To reverse
the direction press the function button FNC.
It will begin to flash. Next press the BAN
button to change directions. Exit the
secondary function feature by pressing FNC
once again. When the band is changed, the A
Frequency, the B Frequency and the Mode
are recalled from the last time the band was
used. Since the Mode is recalled, the Tuning
Rate, and the AGC will also be recalled from
the last time that Mode was used.
Split (28)
To operate SPLIT mode simply press and
hold the A/B button for 2 seconds. The word
SPLIT will appear next to the
B
VFO which
also indicates the frequency you will be
transmitting on. Remember when in SPLIT
mode you will always be transmitting on
VFO
B.
A/B (28)
This Primary Function allows you to toggle
between VFO
A
and VFO
B
each time you
press the button.
A=B (27)
The secondary function of this button allows
you to copy the contents of VFO
A
to VFO
B
To equal both VFO
A
and
B
press FNC
button until it begins to flash. Next, press
A/B button. Exit Function mode by pressing
FNC.
TEN-TEC
AF
RF
MR
AN
SP-CW
BW
PBT
A=B
VOX
PWR
RIT
AGC
PRE
SQL
MON
(
$*/(
NR
MIC
FNC
LOCK
ATTN
FAST
BAN
MOD
TUNE
A/B
NB
