Ten-Tec Eagle 599, Руководство пользователя

Страница: 7 / 32

599 / Eagle Users manual Release 1.002 – September 27, 2010 7
Part #74447
Printed in USA
FNC (12)
The FNC or function button is a vital portion
of this radio. All Secondary Functions of the
Eagles button set are accomplished by
pressing the FNC button. When the FNC
button is first pressed, the FNC button will
begin flashing. You will also see FUNC
blinking on the main screen where the
Bandwidth Value is normally displayed.
Pressing a button using the Secondary
Function will execute that function, either
turning it on or off, or changing its mode, etc.
Pressing the FNC button once again will exit
that secondary feature.
PWR (24)
Power output will be shown on the Eagle
toward the left side of the display. It displays
the output in watts and can be adjusted and
shown as a numeric value from 5-100. To set
the power output simply press the FNC
button (a secondary button function) and then
press TUNE. The multi knob can now be
used to adjust the output. After the power
output has been selected you may exit by
pressing FNC. The digits appearing on the
left of the screen measures the average power
so you will notice the digits may flash a
smaller value when transmitting in side band
mode.
TUNE (25)
If the auto tuner for the Eagle is not turned on
or is not installed this button will generate a
carrier signal for tuning purposes at 20 watts.
This is providing the power output is set at a
minimum of 20 watts. If set lower, it will
transmit a lower level carrier. If the power
output is set anywhere from 20-100 watts the
Eagle will still only tune at 20 watts. This is
an easy and safe way to tune an external
outboard antenna tuner or solid state
amplifier. To increase this power output level
while in the tune positions press FNC (a
secondary button function) and then press
TUNE again. You may now adjust the power
level using the MULTI knob to vary the
output for tuning a linear amplifier.
If the auto tuner is installed and turned on in
the Configuration Menu the TUNE button
will now automatically match the Eagle to the
antenna you are using. You will hear some
clicking noise within the Eagle until the tuner
determines the best match. When finished the
TX light will flash twice plus you will hear a
beep tone from the Eagle. Remember when
using an external tuner or when tuning a
linear amplifier to always go into the
Configuration Menu and turn off the internal
auto tuner.
TEN-TEC
AF RF
MR
AN
SP-CW
BW PBT
A=B
VOX
PWR RIT AGC
PRE
SQL
MON
(
$*/(
NR
MIC
FNC
LOCK
ATTN
FAST
BAN
MOD TUNE
A/B
NB