599 / Eagle Users manual
Release 1.002 – September 27, 2010
16
Part #74447
Printed in USA
VOX: (29)
To toggle the VOX on and off (a secondary
button function) first press FNC until button
and FUNC begin to flash. Next, press the NB
button and you will see VOX appear on the
bottom right side of your screen. Pressing the
NB button each time turns the VOX on and
off. Exit Function mode by pressing FNC
button.
VOX Settings: (30)
To adjust the VOX gain, Anti VOX and VOX
hang (a secondary button function) first press
FNC until button and FUNC begin to flash.
Next, press and hold for 2 seconds the NB
button. This will bring you into the series of
VOX settings. These settings will now toggle
from one to the other upon pressing the NB
button. You can adjust all settings using the
MULTI knob. After you are satisfied with
your VOX adjustments you may exit the
Function mode by pressing the FNC button.
BW Settings: (31)
Normally below 1800 Hz filtering greatly
diminishes the intelligibility of the side band
audio. Above 1800 Hz will increase band
width for increased audio fidelity.
PBT Settings: (32)
Rotating the PBT control during heavy QRM
plus adjusting the filter Bandwidth setting
will greatly reduce close in interference.
Some practice may be necessary to determine
the most comfortable bandwidth and PBT
setting when in crowded band conditions.
Selecting AUX Audio: (11)
To select from either the microphone input or
the rear audio input (5 pin DIN) simply press
the MIC button for 3 seconds and the
designated MIC will disappear from the front
screen. When this happens, the Aux input is
now active. To switch back to the
microphone input simply press and hold the
MIC button again for 3 seconds until MIC
appears back on the screen.
TEN-TEC
AF
RF
MR
AN
SP-CW
BW
PBT
A=B
VOX
PWR
RIT
AGC
PRE
SQL
MON
(
$*/(
NR
MIC
FNC
LOCK
ATTN
FAST
BAN
MOD
TUNE
A/B
NB
