Temsa TS 35, Электроника и руководство по проводке

Страница: 134 / 257

Note:
TEMSA
TS35 05.04.B.fc-1
1- Diagnostic :
To display diagnostic codes using the display of a pushbutton sh ift selector, simultaneously press the UPSHIFT and DOW NSHIFT arrows on the selector.
If an oil level sensor is present, fluid level is displayed first and the UPSHIFT and DOWNSHIFT arrows must be pressed simultaneo usly a second time to
access the diagnostic code readout. The display for each code r epeats continuously until the next code (if present) is accessed by depressing the MODE
button. The following example illustrates the display cycle for the newest code in memory (code P2534 used for illustration purposes):
d1 Code list position (Note: d1=newest code, d5=oldest code in memory)
P Code type
25 Main code
34 Subcode
d1; P; 25; 34 Code repeats until next code (d2) is accessed by depressing the MODE button
If the condition which generated the code is active, the LED ind icator on the selector will be illuminated
simultaneously with the display of the code. If the condition which generated the code no
longer exists, the LED is not illuminated and the code is mainta ined only as a historical record of the
prior condition.
Any of the following methods may be used to exit the diagnostic display mode:
1. With pushbutton shift selectors: Simultaneously depress the U PSHIFT and DOW NSHIFT arrows
or press any range button, D, N, or R. If the shift is not inhib ited by an active code, the TCM will
command the transmission to shift to the selected range.
2. Wait until timeout (approximately ten minutes). The system wi ll automatically return to the normal
operating mode.
3. Turn off the vehicle engine with the ignition switch, which turns off power to the TCM.
Allison Transmissions Electrical System - Diagnostic and Fault Codes