Temperature Guard Input Guard VM500-6, Руководство и инструкции по установке

Страница: 6 / 18

Setting up the Input Guard
Programming is accomplished over the phone and only has to
be done once, unless it is necessary to make a change. Before
programming, do the following:
1 Connect a phone line and power, and then turn on the Input
Guard.
2 From another phone line dial the number where the Input
Guard is located. The device will pick up after the first ring.
3 When prompted, enter the 4-digit PIN number (Factory
default PIN number is 0000).
4 You will hear the Main Menu options (you may enter your
selection at any time):
1. Status
2. Input Setup
3. Program
4. Turn on relay (-R option only)
5. Turn off relay (-R option only)
0. Hang Up
Programming Input Parameters
Each input can be programmed to be either a normally closed or
normally open input.
Each input has its own time delay for which the input must have
changed state for, before the Input Guard begins making
emergency calls. The time delay is programmed in minutes.
Each input has a unique Input ID message that can be recorded
to give further detail during emergency calls.
TIP:
To have the Input Guard callout immediately program a
time delay of 0 minutes.
1.
From the Main Menu, press 2 to setup inputs
2.
You will hear “ Enter Input”
3.
Enter the number of the input which you wish setup (i.
e. 1)
4.
You will hear "Press 1 for normally on or 2 for
normally off"
5.
Enter your selection
6.
You will hear the programmed time delay for the input
6