T. E. L. L. SOFTWARE
HUNGÁRIA KFT
40
Connection type:
You can select from the following two connection types:
Continuous IP connection:
The devices are continuously connected to each other.
Connect, if necessary:
The modules connect each other only for sending data. After the data is sent
they close the connection.
Timeout:
In case of temporary connection this is the time the module waits after the last data was sent
or received before closing the connection.
Network:
Use the dropdown menu to set the communication channel for the device to access the remote
module, and also select the backup communication channel. (
If the module doesn’t have an extension panel
LAN is the only option to choose.)
Maximum data delay:
The module collects the data received on its serial port. If there's no delay in receiving
data, after the amount of time set in this field the module sends the previously collected data to the remote
module.
With these values the response times can be adjusted according to the established serial connection. If the
maximum data delay is smaller, the device waits for fewer data and sends the packet to the remote module
sooner, so the device on the remote module’s serial port receives a quicker response.
Serial port settings:
You can configure the serial port
’s
settings to meet the requirements of the selected
connection type.
For more detailed information on the remote programming of alarm systems, please see the Appendix.
