T. E. L. L. SOFTWARE
HUNGÁRIA KFT
10
You can leave the unused settings in the configuration file, in this case mark them with a
#
character at the
beginning of the line, so that the module ignores them (e.g.:
#ADDRESS="dhcp"
).
Important! In the created file add a
n ENTER at the end of each line and make sure that it doesn’t
contain any further whitespaces (tab, space, etc.).
Configuration sample:
If the A2225C7D806B MAC address was read from the module the path is the following:
import/A2225C7D806B/ipbridge.dnr
If you want the module to use 192.168.1.115 static IP, the 255.255.255.0 netmask, the 192.168.1.0 subnet,
the 192.168.1.1 gateway, the 8.8.8.8 DNS1, the 208.67.220.220 DNS2, the content of the textfile must be
as follows:
ADDRESS="192.168.1.115"
NETMASK="255.255.255.0"
NETWORK="192.168.1.0"
GATEWAY="192.168.1.1"
DNS1="8.8.8.8"
DNS2="208.67.220.220"
To apply the settings in the configuration file insert the pendrive into the module’s USB Host connector.
The
module reads the settings from the file. The pendrive can be removed, when LED1 turns red. After removal
LED1 turns green, the module applies the new settings then reboots. After restarting the LED1 is green.
