9
Playing a reminder
The recorded reminders can be replayed by pressing shortly the corresponding 1-4
function keys, provided that there has been assigned a reminder to the given key
previously.
Erasing a reminder
Steps of reminder erasing:
1) Press the Settings
key continuously for at least 5 seconds, then “
PASS
”
is displayed on the digital display
2) Enter the user password using the 1-4 function keys (the password is: 1111)
3)
The “MEM” LED becomes lit
4) The LED found above each 1-4 function key is lit if there is already a reminder
assigned to the given key
5) Keep pressed for at least 5 seconds the function key (1-4) assigned to the
reminder to be erased.
The LED found above the key turns off and “- - - -” is
displayed on the digital display
6) If you wish to erase further reminders, repeat the previous step (5)
7) When finished, press Cancel
key to exit the programming mode
8) If you have not deleted all the reminders, the "MEM" LED remains lit green
Confirming a reminder
The user can confirm the reminder by pressing the Cancel
key while the reminder
is being played. If no confirmation is done, the message will be repeated in the
configured intervals (5 to 30 seconds). If the reminder is still not confirmed after being
repeated according to the configured number of repetition (1 to 10), the module
generates “
Reminder unacknowledged
” event which initiates SMS sending or call
according to the settings. The delay between reminder repetitions and the number of
repetitions can be configured using the programming software.
2.4.4 Starting an emergency call
Emergency calls can be initiated by pressing the Emergency
key or by pressing the
button on the RF transmitter. In case of initiating an emergency alarm using the RF
transmitter, the transmit
ter’s LED indicator starts flashing with red light, thereby
indicating that signal transmission is in progress. The transmitter’s LED indicator turns
green for 1-2 seconds if the signal transmission towards the device was successful, i.e.
the device confir
med the reception. In case that the transmitter’s LED indicator keeps
flashing with red light, it means that for some reason the signal does not reach the
device, or the device’s confirmation does not reach the RF transmitter (i.e. the RF
transmitter is ou
tside the operating range). At a single press of the RF transmitter’s
button the RF transmitter tries to send the signal towards the device once per second,
altogether 100 times, i.e. through 100 seconds. The operating range of the RF
transmitter depends on the local reception conditions
, therefore it is the installer’s
responsibility to test the proper operation on the scene, as well as to mount the unit in
the most optimal place, where it will be
able to receive the RF transmitter’s signals from
the desired distances, taking into account that the operating range of the RF transmitter
decreases when its battery weakens.
