2.5.1 Using The Reset Button
Step 1.
Make sure the SYS LED is on (not blinking).
Step 2.
Press the RESET button for more than 6 seconds, and then release it. When the SYS
LED begins to blink, the defaults have been restored and the TELKOM ADSL 5100 restarts.
2.5.2 Uploading a Configuration File Via Console Port
Download the default configuration file from the website www.telkomphones.co.za, unzip it and
save it in a folder.
Step 1.
Turn off the TELKOM ADSL 5100, begin a terminal emulation software session and turn
on the TELKOM ADSL 5100 again. When you see the message "Press Any key to enter
Debug Mode within 3 seconds", press any key to enter debug mode.
Step 2.
Enter "atlc" after "Enter Debug Mode" message.
Step 3.
Wait for "Starting XMODEM upload" message before activating Xmodem upload on your
terminal. This is an example Xmodem configuration upload using HyperTerminal.
Step 4.
Click Transfer, then Send File to display the following screen.
Step 5.
After successful firmware upload, enter "atgo" to restart the router.
12
