HW User Guide
1vv0301018 Rev. 15
Page
25
of
72
2019-01-07
General Design Rules
The principal guidelines for the Power Supply Design embrace three different design steps:
•
the electrical design
•
the thermal design
•
the PCB layout.
6.3.1.
Electrical Design Guidelines
The electrical design of the power supply depends strongly on the power source from which
this power is drained. We will distinguish them into three categories:
•
+5V input (typically PC internal regulator output)
•
+12V input (typically automotive)
•
Battery
+ 5V input Source Power Supply Design Guidelines
•
The desired output for the power supply is 3.8V, hence there's not a big difference
between the input source and the desired output and a linear regulator can be used.
A switching power supply will not be suited because of the low drop out
requirements.
•
When using a linear regulator, a proper heat sink shall be provided in order to
dissipate the power generated.
•
A Bypass low ESR capacitor of adequate capacity must be provided in order to cut
the current absorption peaks close to the GL865 V3/V3.1
, a 100μF tantalum
capacitor is usually suited.
•
Make sure the low ESR capacitor on the power supply output (usually a tantalum
one) is rated at least 10V.
•
A protection diode should be inserted close to the power input, in order to save the
GL865 V3/V3.1 from power polarity inversion.
An example of linear regulator with 5V input is:
Содержание GL865 V3
Страница 1: ...01 2017 Mod 0805 2017 01 Rev 6 GL865 V3 V3 1 HW User Guide 1vv0301018 Rev 15 2019 01 07...
Страница 64: ...HW User Guide 1vv0301018 Rev 15 Page 64 of 72 2019 01 07...
Страница 66: ...HW User Guide 1vv0301018 Rev 15 Page 66 of 72 2019 01 07 14 2 1 Carrier tape detail 14 2 2 Carrier detail...
Страница 72: ...01 2017 Mod 0805 2017 01 Rev 6...
