Televic Confidea, Инструкция по установке и эксплуатации

Страница: 51 / 69

Confidea Wireless System Installation and User Manual
Televic Conference Systems 2008-09-05 51
Only the units that are have been initialized and
listed in the Init List will now be able to join the
conference.
The init list is stored in the WCAP and stays in
memory even after switching the WCAP off.
Next time the WCAP and delegate units are switched
on, only these units that are in the Init List will be
allowed to connect to the
WCAP .
13.2.5. Adding a new unit in
‘Open Access’ mode
In ‘ Open access ’ mode, adding a unit requires simply
to switch the unit on.
It will then automatically connect to the WCAP in
operation.
13.2.6. Adding a new unit in
‘Controlled Access’ mode
In a ‘ Controlled Access ’ set-up, adding a unit requires
the following steps:
14. Switch on the wireless unit to add and wait a
few seconds until the unit has discovered the
WCAP (see chapter xxx)
15. Open the existing initialization by selecting the
“Start Init”, , button.
16. After you started the new initialization, the LED’s
on the wireless unit(s) will start to blink. The
LED’s on the units that are already known in the
init list will automatically go out.
17. Add the new wireless unit(s) by pressing the
microphone button on the unit(s).
18. Stop and save the initialization by pressing the
“Save and Stop Init” button, .
Note:
When multiple WCAP s with ‘Open
Access’ are in operation in the same
area, there is no control over which
WCAP the new unit will connect to.