Televic Confidea, Инструкция по установке и эксплуатации

Страница: 31 / 69

Confidea Wireless System Installation and User Manual
Televic Conference Systems 2008-09-05 31
10.2.4. Tripod Mounting
The WCAP can also be mounted on a tripod.
Figure 10.3: Tripod mounting
10.2.5. Antennas
The WCAP has 3 antennas which can be positioned in
different directions independent from each other.
10.4: Antenna mounting
10.3. Connections and
Controls
Figure 10.5: WCAP connections
1. Power Switch
The WCAP can be switched off with the power
switch at the back of the WCAP.
2. Power Supply
The power supply of the wireless delegate and
interpreter units is provided by batterypacks
(see also chapter 2.3)
The power supply of the WCAP is provided by a
220VAC/24VDC adaptor
The WCAP can also be powered like a SDC8200
or TCS2500 wired delegate unit (48VDC) or by
connecting it to a SPL5000 ; in both case no
seperate power supply is needed . (see also
Chapter 4)
3. Digital Bus Connection
Digital Bus connection is done through RJ45-
connectors at the back of the WCAP.
Connections can be made to CE2500 or SPL5000.
4. Bracket
….
5. LAN connection
Through the LAN connector at the back of the
WCAP, a PC can be connected using a standard
network cable
6. Status LEDS
The status LEDs give information on selected
mode, RF link quality (Signal/Noise Ratio) and
delegate unit detection (see Figure 10.6, Table
10.1, Table 10.2 and Table 10.3).
Caution:
Only use antennas supplied by Televic.
Use of other antennas can cause damage
to the unit, reduce system performance
and