Televic Confidea, Инструкция по установке и эксплуатации

Страница: 46 / 69

Confidea Wireless System Installation and User Manual
Televic Conference Systems 2008-09-05 46
12.3.2. Unit Monitoring
Init State
Units Initialized: Displays the number of
initialized units currently linked to the system.
Units in Init List: Displays the total number of
initialized units.
Unit List
In this section a unit summary is displayed.
Microphone Number:
Displays the microphone number.
Serial Number:
Displays the unit serial number.
Status:
Displays the unit status. Units can either be
‘
Connected ‘or ‘ Disconnected’ .
Link Quality:
Displays an indication of the quality of the radio
link the unit and the Confidea access point. The
quality is expressed as
Excellent , Good , Fair and
Low .
Battery Status:
Displays the remaining battery capacity. The
value indicates how many hours the unit can still
be used before the rechargeable battery is
depleted.
12.3.3. Init Units
Init State
Units Initialized:
Displays the number of initialized units currently
linked to the system.
Units in Init List:
Displays the total number of initialized units
included in the list
Init
Init Control:
Open Access:
When the system is set to ‘Open Access’ any
delegate or chairman unit that powers up within
the range of a Confidea Access Point will log
itself on to that access point, and its ID will be
added to the Init List
Manual:
In manual mode, each units needs to be
initialized manually before it is added to the Init
List.
‘Start Init’:
Pressing this control will start an initialization
cycle. Pressing the microphone button of each
unit that needs to log on to the system will
register that unit with the Access Point.
‘ Save and Stop Init’ :
This will stop the initialization and save the init
list to memory. To add more units, restart the
init cycle.
Note:
During the first minutes a unit is switched
on, the battery status is not accurate and
higher values can be displayed. This is
normal and due to the typical behavior of
batteries.
Note:
The information on the unit monitoring
page is not refreshed automatically.
To view the most recent condition of the
system, click the “
Refresh Unit Table ”
button.