Important Compliance and Safety Information
12
PRISM MPS Installation and Safety Instructions
While using this product, you may need to access other parts of a larger system. Read
the safety sections of the other component manuals for warnings and cautions related
to operating the system.
When incorporating this equipment into a system, the safety of that system is the
responsibility of the assembler of the system.
To Avoid Fire or Personal Injury
Use proper power cord:
Use only the power cord specified for this product and certified
for the country of use. Do not use the provided power cord for other products.
Ground the product:
This product is grounded through the grounding conductor of the
power cord. To avoid electric shock, the grounding conductor must be connected to
earth ground. Before making connections to the input or output terminals of the
product, ensure that the product is properly grounded. Do not disable the power cord
grounding connection.
Power disconnect:
The power cord disconnects the product from the power source. See
instructions for the location. Do not position the equipment so that it is difficult to
operate the power cord; it must remain accessible to the user at all times to allow for
quick disconnection if needed.
Observe all terminal ratings:
To avoid fire or shock hazard, observe all rating and
markings on the product. Consult the product manual for further ratings information
before making connections to the product. Do not apply a potential to any terminal,
including the common terminal, that exceeds the maximum rating of that terminal.
Do not operate without covers:
Do not operate this product with covers or panels
removed, or with the case open. Hazardous voltage exposure is possible.
Avoid exposed circuitry:
Do not touch exposed connections and components when
power is present.
Do not operate with suspected failures:
If you suspect that there is damage to this
product, have it inspected by qualified service personnel.
Disable the product if it is damaged.
Do not use the product if it is damaged or operates
incorrectly. If in doubt about safety of the product, turn it off and disconnect the power
cord. Clearly mark the product to prevent its further operation.
Before use, inspect voltage probes, test leads, and accessories for mechanical damage
and replace when damaged. Do not use probes or test leads if they are damaged, if
there is exposed metal, or if a wear indicator shows.
Examine the exterior of the product before you use it. Look for cracks or missing pieces.
Use only specified replacement parts.
Do not operate in wet/damp conditions: Be aware that condensation may occur if a
unit is moved from a cold to a warm environment.
Do not operate in an explosive atmosphere.
