Telenetics OM-AMPS-100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 23 / 70

Section 1 Contents
OMEGA Installation, Operation, and Maintenance Manual 23
and the one after it to test OMEGA’s ability to originate and
answer calls.
IMPORTANT: If reception is poor, place the cover on
OMEGA to shield the transmission from
radiating energy to the transceiver.
To test OMEGA’s ability to originate a call:
1.
Disconnect the external modem from the OMEGA RJ-11
modem jack.
2. Connect a standard telephone to the OMEGA RJ-11 modem
jack. This jack is located on the side opposite the cellular
transceiver connector (see Figure 1-1 on page 13).
3. Use the telephone to dial a call. If you make a connection, it
indicates that the OMEGA cellular transceiver can originate
calls.
NOTE:
The modem that came with the endpoint device may provide
additional ways to test the modem’s dial-out capabilities. Refer to
the manual that came with the modem for more information.
Call Answer Testing
To test OMEGA’s ability to answer a call:
1. With the telephone connected to the OMEGA modem RJ-11
jack, use another telephone to call OMEGA. The telephone
attached to OMEGA should ring.
2. Remove the telephone and reconnect the endpoint device to the
modem jack connection on OMEGA. Have a remote modem
call OMEGA. The modem connected to OMEGA should
answer the call automatically.
If the modem fails to automatically answer the calls, make sure the
modem used with the endpoint device is configured for auto-
answer (refer to the manual that came with the modem for more
information).