Teledyne PDS - Teledyne PDS, T20-P and POS MV Quick Setup
Interfacing
3
2 Interfacing
2.1 Introduction
In this section the basic setup of a RESON T20-P, a POS MV and the
Teledyne PDS computer with the connections are described.
2.2 Connections
Figure 2-1 shows the rear panel with the connectors of a T20-P.
Figure 2-1
Rear panel RESON T20-P
Figure 2-2 shows the rear panel with the connectors of a POS MV.
Figure 2-2
Rear panel Applanix POS MV
The Teledyne PDS software,
the POS MV’s POSView software and the
SeaBat User Interface (SUI) are installed on a computer. The POS MV,
the RESON T20-P and the computer are linked to each other by an
Ethernet connection. (An Ethernet switch is used for this purpose.) The
T20-P need serial motion data for its roll stabilization feature. A PPS
signal with a timing message from the POS MV is needed for correct time
synchronization.
Schematically a setup is represented as:
