Teledyne Princeton Instruments PICam 5.x, Руководство программиста

Страница: 91 / 357

Chapter 5 Configuration APIs 91
PicamParameter_SensorTemperatureSet
Point
Controls the target temperature for the sensor in degrees C.
PicamParameter_SensorTemperatureStatus
Reports the status of the sensor temperature via the
PicamSensorTemperatureStatus data enumeration.
Refer to Section 5.1.1.29, PicamSensorTemperatureStatus , on
page 96 for additional information.
PicamParameter_SensorType
Reports the kind of sensor being used via the
PicamSensorType data enumeration.
Refer to Section 5.1.1.30, PicamSensorType , on page 97 for
additional information.
PicamParameter_SeNsRWindowHeight
Controls the height of the unmasked area used in SeNsR
readout.
PicamParameter_SequentialEndingGate
Controls the last gate pulse in a sequence in nanoseconds
(nS).
PicamParameter_SequentialEnding
ModulationPhase
Controls the last modulation phase of the intensifier with
respect to the modulation output signal in a sequence in
degrees.
PicamParameter_SequentialGateStepCount Controls the number of gate pulse steps in a sequence.
PicamParameter_SequentialGateStep
Iterations
Controls the number of gate pulses at each step in a
sequence.
PicamParameter_SequentialStartingGate
Controls the first gate pulse in a sequence in nanoseconds
(nS).
PicamParameter_SequentialStarting
ModulationPhase
Controls the first modulation phase of the intensifier with
respect to the modulation output signal in a sequence in
degrees.
PicamParameter_ShutterClosingDelay Controls the duration of time the hardware waits for the
shutter to close before reading out.
The time unit depends on
PicamParameter_ShutterDelayResolution
.
PicamParameter_ShutterDelayResolution Controls the time unit used for shutter opening/closing delay.
This value is in microseconds.
Example: A resolution of:
• 1 signifies delay is in microseconds (

S);
• 1000 for milliseconds (mS);
• 0.01 for tens-of-nanoseconds (nS).
PicamParameter_ShutterOpeningDelay
Controls the duration of time the hardware waits for the
shutter to open before exposing.
The time unit depends on
PicamParameter_ShutterDelayResolution .
PicamParameter_ShutterTimingMode
Controls the behavior of the shutter during acquisition.
Refer to
Section 5.1.1.32, PicamShutterTimingMode , on
page 98 for additional information.
PicamParameter_StopCleaningOnPre
Trigger
Stops sensor cleaning when an external pre-trigger is
acknowledged.
Table 5-23:
PicamParameter
Enumerator Definitions (Sheet 9 of 11)
Enumerator Description