Teledyne Princeton Instruments PICam 5.x, Руководство программиста

Страница: 84 / 357

84 PICam™ 5.x Programmer’s Manual Issue 11
PicamParameter_CcdCharacteristics
Reports characteristics of a CCD sensor via the
PicamCcdCharacteristicsMask data enumeration.
Refer to Section 5.1.1.4, PicamCcdCharacteristicsMask , on
page 73 for additional information.
PicamParameter_CenterWavelengthReading
Reports the actual position of the center wavelength in
nanometers (nm).
PicamParameter_CenterWavelengthSet
Point
Controls the target position of the center wavelength in
nanometers (nm).
Refer to
Section 5.1.1.5, PicamCenterWavelengthStatus , on
page 74 for additional information.
PicamParameter_CenterWavelengthStatus
Reports if the center wavelength is moving.
PicamParameter_CleanBeforeExposure Controls cleaning before each exposure.
PicamParameter_CleanCycleCount
Controls the number of clean cycles to run before acquisition
begins.
PicamParameter_CleanCycleHeight
Controls the number of rows in a clean cycle.
PicamParameter_CleanSectionFinalHeight Controls the final height rows for exponential decomposition
cleaning.
PicamParameter_CleanSectionFinalHeight
Count
Controls the final height iterations for exponential
decomposition cleaning.
PicamParameter_CleanSerialRegister Controls the cleaning of the serial register itself.
PicamParameter_CleanUntilTrigger
Controls the nature of cleaning while waiting for an external
trigger.
PicamParameter_CoolingFanStatus
Reports the status of the cooling fan via the
PicamCoolingFanStatus data enumeration.
Refer to Section 5.1.1.7, PicamCoolingFanStatus , on page 75
for additional information.
PicamParameter_CorrectPixelBias
Enables pixel bias correction.
PicamParameter_CustomModulation
Sequence
Customizes a modulation sequence.
PicamParameter_DelayFromPreTrigger Specifies the delay from pre-trigger to trigger in
microseconds (

S).
PicamParameter_DifEndingGate
Controls the second gate pulse in DIF readout in
nanoseconds (nS).
PicamParameter_DifStartingGate
Controls the initial gate pulse in DIF readout in nanoseconds
(nS).
PicamParameter_DisableCoolingFan
Enables/disables the thermoelectric cooling fan.
PicamParameter_DisableDataFormatting Controls the basic processing necessary to receive data in the
expected format.
PicamParameter_EMIccdGain Optimally controls the intensifier gain and electron
multiplication gain in emICCD hardware in terms of multiples.
Table 5-23:
PicamParameter
Enumerator Definitions (Sheet 2 of 11)
Enumerator Description