Teledyne Princeton Instruments PI-MTE, Системное руководство

Страница: 14 / 118

14 PI-MTE System Manual Issue 6
2.1.3 Controller Connector
Power, control signals, and data are transmitted between the ST-133 and the PI-MTE
camera via the 25-pin D connector located on the rear of the camera. Controller power
must be OFF before connecting to or disconnecting from this connector or to the
equivalent connector on a vacuum flange.
2.2 ST-133 Controller
The ST-133 controller is a compact, high performance CCD Detector
Controller for operation with Teledyne Princeton Instruments
brand
a
detectors. Designed for high speed and high performance
image acquisition, the ST-133 offers data transfer at speeds up to
1 megapixel per second, standard video output for focusing and
alignment. A variety of A/D converters are available to satisfy speed
and resolution requirements.
In addition to containing the power supply, the controller contains the analog and
digital electronics, scan control and exposure timing hardware, and controller I/O
connectors, all mounted on user-accessible plug-in modules. This highly modularized
design gives flexibility and allows for convenient servicing.
2.2.1 POWER Switch and Indicator
The power switch location and characteristics depend on the version of ST-133
Controller that was shipped with your system. In some versions, the power switch,
located on the front panel as illustrated in
Figure 2-1 , has an integral indicator LED that
lights whenever the ST-133 is powered. In other versions, the power switch is located
on the back of the ST-133 and does not include an indicator LED.
Figure 2-1: Power Switch Locations (ST-133A and ST-133B)
a. The ST-133 controller must be factory configured for operation with a TE-cooled camera. For
this reason, a controller purchased for operation with a TE-cooled camera can only be used with
TE-cooled camera. It cannot be used to control an LN-cooled camera.
4
4
11
-00
9
7_
0002
4
4
11-
009
7_
0
003