Teledyne DALSA Piranha PC-30-02K60-00-R, Руководство пользователя, Страница: 14 / 96

Piranha Color Camera 14
!
Note: Refer to the following sections for details on equipment recommendations and
camera connector information.
2.3 Camera LED
The camera is equipped with a red/green LED used to display the operational status of
the camera. The table below summarizes the operating states of the camera and the
corresponding LED states.
When more than one condition is active, the LED indicates the condition with the
highest priority. The fatal error state is accompanied by corresponding messages further
describing the problem.
Table 1: Diagnostic LED
Priority Color of Status LED Meaning
1 Flashing Red Fatal Error. For example, camera temperature is too
high and camera thermal shutdown has occurred.
2 Flashing Green Camera initialization or executing a long command
(e.g., flat field correction commands
ccp
or
ccf
).
During this state, any other sent command is ignored.
3 Solid Green Camera is operational and functioning correctly and
ready to receive commands.
2.4 Power Connector
Figure 2: Hirose 6-pin Circular Male — Power Connector
Hirose 6-pin Circular Male
5
4
6
2
3
1
Mating Part: HIROSE
HR10A-7P-6S
The camera requires a single voltage input (+12 V to +15 V). The camera meets all
performance specifications using standard switching power supplies, although well-
regulated linear supplies provide optimum performance.
WARNING: When setting up the camera’s power supplies follow these guidelines:
 12 V to +15 V at the camera power input (after the voltage drop across
the power cable. This may mean that the power supply will have to provide a
voltage greater than the required camera voltage. For example, to a12 V at
the camera, the power supply may need to be +12.5 V or greater.

Protect the camera with a fast-blow fuse between power supply and camera.
 Do not use the shield on a multi-conductor cable for ground.

Keep leads as short as possible to reduce voltage drop.

Use high-quality linear supplies to minimize noise.
 Use an isolated type power supply to prevent LVDS common mode range
violation.
Note: Camera performance specifications are not guaranteed if your power supply
does not meet these requirements.
Table 2: Hirose Pin Description
Pin Description Pin Description
1 Min +12 to Max +15V 4 GND
2 Min +12 to Max +15V 5 GND
3 Min +12 to Max +15V 6 GND