Teledyne 7 RU Chassis, Руководство по эксплуатации, Страница: 37 / 144

Operations Manual, 7RU SSPA Chassis 208528 REV M 37
•
LastFault – This parameter shows information about the last detected fault. The
value is latched to the last fault occurrence. Use the Clear Fault function to re-
set. Possible Values:
○ LowRF – Low RF level fault;
○ AuxFlt – Auxiliary fault;
○ BUCFlt – Block Up converter fault;
○ PSFlt - Power Supply fault;
○ ColdSt – Unit cold start power up detected;
○ N+1Flt – N+1 System Fault;
○ TmpFlt – High temperature fault;
○ RegFlt – Voltage Regulator fault;
○ CurFlt – Low DC Current fault;
○ HiVSWR – High reflected RF level fault;
○ Other – Unknown fault condition;
○ None – No information about present or past fault conditions (Clear Fault
function was implemented by user);
3.1.11 IP Info Page 1
This page is available through the Comm. Setup menu, and shows SSPA settings related to
the IP interface.
•
IP Address – IP address of the SSPA. Consult your network administrator to
set this address according to your LAN configuration.
•
MAC – Medium Access Control address of the SSPA Ethernet controller. This
address is factory preset.
•
Subnet – IP subnet mask of the SSPA. Consult your network administrator to
set this address.
•
IPPort – IP port value for the SSPA. This address is valid only when IPNet pro-
tocol is selected. The port value should not be selected outside the existing ser-
vices range to avoid access conflict on the M&C PC end.
3.1.12 IP Info Page 2
This page shows SSPA settings related to the IP interface.
•
Gateway – IP Gateway address. This address is used only if access to the
SSPA is provided from an outside LAN. If no such access is required, the ad-
dress must be set to 0.0.0.0
•
LockIP – This address is used to increase the security measure for the IPNet
protocol. The SSPA will answer a request which comes only from a specified IP
address. Set this address value to 255.255.255.255 to disable this feature. See
Section 3.2.5.1 .