TELEDYNE OLDHAM SIMTRONICS OLCT 80 d, Руководство пользователя

Страница: 81 / 116

OLCT 80
GAS TRANSMITTER
USER MANUAL
NPO80GB
Revision F.1
75
9 Maintenance
Maintenance mainly involves replacing any sensors that no longer meet their original
metrological specifications.
The operations explained in this section must be performed by authorized, qualified
personnel because they could affect detection reliability. Inspection and maintenance
must be carried out in accordance with the current editions of EN60079-17 and
eventually with any local or national additional requirements that may apply in the
country of installation.
9.1 Possible transmitter errors
The table below lists various potential detector errors.
Fault observed Possible cause Action Page
0 mA line
current
Connection cable Check the cable. -
Power supply Check the voltage at the transmitter's terminals (see
Alim V
under the
Maintenance
menu).
41
Electronic board Replace the board. -
Line current
> 0 mA and <
1mA Sensor Replace the sensor (see
Sensor Replacement
menu).
45 and 76
Line resistance too high Check the cable.
Power supply Check the voltage at the transmitter's terminals (see
Alim V under the Maintenance menu).
41
Improper calibration gas Check the concentration of the calibration gas -
Check the input value (see Calibration gas under
Sensor Replacement
menu)
44
Zeroing not
possible Sensor Replace the sensor (see
Sensor Replacement
menu).
45 and 76
Sensitivity
adjustment
impossible Sensor Replace the sensor (see
Sensor Replacement
menu).
45 and 76
"
SUP
" displayed Verification required Acknowledge verification. 67