Teledyne Lecroy WaveSurfer 10, Руководство по началу работы

Страница: 43 / 46

REFERENCE 39
Safety Compliance
EC DECLARATION OF CONFORMITY – LOW VOLTAGE
The oscilloscope meets the intent of EC Directive 2006/95/EC for Product
Safety. Compliance was demonstrated to the following specifications as
listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment
for measurement, control, and laboratory use – Part 2-030: Particular
requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following
limits put forth by these standards:
•
Mains Supply Connector: CAT II, local distribution level, equipment
connected to the mains supply (AC power source).
•
Measuring Terminals: CAT O, signal level, equipment measuring
terminals connected to source circuits where measures are taken to
limit transient voltages to an appropriately low level.
•
Unit: Pollution Degree 2, operating environment where normally only
dry, non-conductive pollution occurs. Conductivity caused by temporary
condensation should be expected.
•
Unit: Protection Class I, grounded equipment, in which protection
against electric shock is achieved by Basic Insulation and a connection
to the protective ground conductor in the building wiring.
U.S. NATIONALLY RECOGNIZED AGENCY CERTIFICATION
The oscilloscope has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears UL Listing Mark:
UL 61010-1 Third Edition – Safety standard for electrical measuring and
test equipment.
CANADIAN CERTIFICATION
The oscilloscope has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears cUL Listing Mark:
CAN/CSA-C22.2 No. 61010-1-12. Safety requirements for electrical
equipment for measurement, control and laboratory use.
Environmental Compliance
END-OF-LIFE HANDLING
The instrument is marked with this symbol to indicate that it
complies with the applicable European Union requirements
to Directives 2002/96/EC and 2006/66/EC on Waste
Electrical and Electronic Equipment (WEEE) and Batteries.
The instrument is subject to disposal and recycling regulations that
vary by country and region. Many countries prohibit the disposal of
waste electronic equipment in standard waste receptacles. For more
information about proper disposal and recycling of your Teledyne LeCroy
product, please visit teledynelecroy.com/recycle.
RESTRICTION OF HAZARDOUS SUBSTANCES (RoHS)
This instrument and its accessories conform to the 2011/65/EU RoHS2
Directive, as it has been classified as Industrial Monitoring and Control
Equipment (per Article 3, Paragraph 24) and is exempt from RoHS
compliance until 22 July 2017 (per Article 4, Paragraph 3).
ISO Certification
Manufactured under an ISO 9000 Registered Quality Management
System.