Teledyne Lecroy WaveSurfer 10, Руководство по началу работы

Страница: 15 / 46

SET UP 11
Carrying
The oscilloscope’s case contains a built-in carrying handle. Always unplug
the instrument from the power source before lifting and carrying it.
Powering On/Off
Connect the line cord rated for your country to the AC power inlet on the
back of the instrument, then plug it into a grounded AC power outlet.
(see Power and Ground Connections in “General Safety Information”).
The Power button on the front controls the operational state of the
oscilloscope. Press the button to switch on the instrument; press the button
again or use the File > Shutdown menu option to switch “off” (Standby).
CAUTION. Do not change the instrument’s Windows® Power
Options from the default. System Standby or System Hibernate
modes should never be used.
CAUTION. Do not power on or calibrate the oscilloscope with a
signal attached.
Pressing and holding the Power button executes a “hard” shutdown, same
as on a PC, but we do not recommend doing this as it does not allow the
Windows operating system to shut down properly.
The Power button does not disconnect the oscilloscope from the AC
power supply; some “housekeeping” circuitry continues to draw power.
The only way to fully power down the instrument is unplug the AC line
cord from the outlet.
CAUTION. Do not place the instrument so that it is difficult to
reach the power cord in case you need to disconnect from power.
We recommend unplugging the instrument if it will remain unused for a
long period of time.
Connecting
After start up, configure the oscilloscope connections using the menu
options listed below. See the WaveSurfer 10 Oscilloscopes Operator’s
Manual for more detailed instructions.
USB Peripherals
Connect the device to a USB port on the front or side of the instrument.
Printer
WaveSurfer 10 supports USB or network printers. Connect the printer to
any host USB port or place it on the same network as the oscilloscope. Go
to
Utilities > Utilities Setup > Hardcopy to configure printer settings.
External Controller
Connect an Ethernet cable from a LAN port on the side of the instrument
to the controller. Go to Utilities > Preference Setup > Remote to configure
remote control using TCPIP or LXI.
External Monitor
WaveSurfer 10 supports external VGA monitors. Attach the monitor cable
to the VGA connector on the side of the instrument. Go to
Display >
Display Setup > Open Monitor Control Panel to configure display settings
using the standard Windows control panel dialogs. If the second monitor
is capable of being used as a touch screen, you can configure it to
duplicate the controls seen on the oscilloscope screen.
Note: External monitors with Fujitsu drivers cannot be used as touch
screens, only as displays.