1.
Place the Extension bracket aligned with the alignment holes in the PCB (marked G4 M.2 M-Key Cable 2230). The bot-
tom of the PCB is shown below.
2.
Select the appropriate bracket for your application (Type-2242 as example here).
3.
Make sure the text "Type - 2242" on the bracket is facing the top of the PCB where the cables are attached.
4.
The extension bracket with clip is to be inserted into the Interposer Cable Assembly PC Board.
(A Type - 2242 Extension Bracket is shown being inserted into an M-Key Type Cable Assembly PC Board below just as
an example. The cable soldered to the top of the PCB was removed in the drawing below for clarity.)
5.
Insert the Extension bracket with the clip into the PCB with cables attached. Ensure that the alignment pins on the
bracket slip into the holes on the PCB. It may be easier to install the bracket one alignment pin at a time. First, push the
lower alignment pin into the lower PCB hole and then slide-in the bracket and push the second alignment pin into the
second PCB hole. See the images below.
6.
The view from the top side of the PCB is shown below with a Type-2280 Extension Bracket.
Warning
!
Attempting to use the board without the extension bracket and properly secured to the host will cause damage
to the plug-in card of the interposer cable and warranty will be voided.
