For this cable configuration screws are used to hold the bracket to the PC Board. The assembly process for swapping the
default Type 2260 bracket with the Type 2280 is described below (follow the same steps for the Type 22110 bracket).
1.
First remove the two Phillips head screws, then remove the Type 2260 Extension bracket.
2.
Place the Type 2280 Extension bracket aligned with the counter sink screw holes.
3.
Make sure the text "Type 2280" on the bracket is facing the top of the PCB where the cables are attached.
4.
Insert the screws and tighten them using a 1.4mm Phillips or flat blade screw driver.
5.
The view from the top side of the PCB is shown below. The text "Type 2280" is clearly visible.
Attach
ing the
Cables to
the
Interposer
1.
Once the cable assembly has been completed (Method One or Method Two) the next step is to attach the cables to the
Interposer as shown below.
2.
Connect the cable ends to the interposer pod. There is a power cable, a sideband signals cable and a high speed sig-
nals cable. These three cables have different connectors and are keyed. Be careful to install the connectors in the right
orientation (following labels) and do not force them. See diagram below.
Phillips head
screws
Warning
!
Attempting to use the board without the extension bracket and properly secured to the host will cause
damage to the plug-in card of the interposer cable and warranty will be voided.
