12
Prior to installation, please check out the security equipment of the
crane, and crane must be in normal working condition.
Make sure you are fully understanding the crane circuits and power
distribution as well as the function setting of remote controller
(with relay output), to avoid incorrect wiring.
Receiver cannot be installed in the electrical control box, the
correct way is to install the receiver on the appropriate location (for
example: the top side (or external) of control box), then have the
receiver output cables into the electrical control box to make the
appropriate connections.
2-2 Transmitter installation instructions
The release ribbon must be under the batteries, and then Insert
batteries in proper direction into battery compartment. Attach and
screw the battery cap on the bottom of the transmitter
2-3 Receiver Installation Instructions
2-3-1 Preparation for Installation
1.
Provide all necessary tools.
2.
Select a proper location.
a) Select a stable place
。
b) Select a place where you can see the Receiver or Antenna.
c) Select a place where there is no spark, e.g. keep away from
motors, relays, magnetic switch and power cables.
d) Keep away from high-voltage wiring and device.
e) The spacing between Receiver’s box and other obstacles must
keep away for more than 3 cm.
3.
Set appropriate power source
The input power source for receiver can be 48 VAC 50/60 Hz,
110VAC, 50/60 Hz or 220VAC, 50/60 Hz, or 380VAC, 50/60
Hz. After power source is confirmed, one must connect the
connector of initial coil of transformer to the relay module
properly.
2-3-2 Receiver installation order
1.
Turn off the main power for crane.
2.
Drill the holes for screws, install receiver and then fix the
receiver with screw nut.
3.
Connect the cable-assembly (provided) to the receiver and
