End user instructions
│
T9/T11
│
Chapter 8: Foils
CHAPTER 8: FOILS
Foils are used to customized transmitters depending on the application. Tele Radio
AB foils are made of durable, soft, flexible GO-PU/SM polyurethane film with a
semi-matt surface on the front side.
Before affixing a foil to a transmitter, read the recommendation below.
l
To obtain optimum adhesion, the bonding surfaces must be clean, dry and
well unified. Some typical surface cleaning solvents are isopropyl alcohol
(99.5%) or heptane.
NOTE: Carefully read and follow the manufacturer’s precautions and
directions for use when working with solvents. These cleaning
recommendations may not be compliant with the rules of certain Air
Quality Management Districts in California; consult applicable rules before
use.
l
Ideal tape application temperature range is 21 °C to 38 °C ( 70 °F to 100 °F).
l
Initial tape application to surfaces at temperatures below 10 °C (50 °F) is not
recommended because the adhesive becomes too firm to adhere readily.
However, once properly applied, low temperature holding is generally
satisfactory.
8 .1 Af f ix a f oil to the transmitter
1. Wipe the front of the transmitter with rubbing alcohol or other appropriate
cleaner that won't leave any residue.
2. Dry with a clean cloth.
3. Peel off one side of the backing paper.
4. Position the side of the foil on the corresponding side of the transmitter.
5. While holding onto the side, gently press the foil onto the surface from the
side out to the center.
6. Peel away the rest of the backing paper .
7. Slowly apply the other side of the foil, gently press from the center to the
end.
8. Inspect the foil. If you see loose areas or bubbles, the surface probably
wasn't warm or clean enough. Press the foil firmly against the surface to
ensure good adhesion.
ED-TG2-TX102-EN-v02
33
