End user instructions
│
T9/T11
│
Chapter 6: Operation
6.7 Log the transmitter ou t f rom a receiver
A transmitter already logged in to the receiver has to be logged out before any
other transmitter can be logged in. If a transmitter has been lost or seriously
damaged, use the replace procedure on the transmitter.
NOTE: Logout can only be performed when the transmitter is on and a radio link
with one or more receivers has been established. The receiver must be powered-
up for the logout procedure to be successful.
NOTE: The logout procedure will log the transmitter out from all receivers that
are part of the radio session.
6.7 .1 Q UI C K L O G O UT
1. Make sure that the transmitter is started. If not, twist and release the
Stop
button.
2. Press and hold the
left Start
button.
1
3. Press the
Stop
button.
The top LED lights (red).
3. Release the
left Start
button.
The transmitter takes approximately 3 seconds to logout.
If successfully completed, the display shows
[Logout OK]
. The transmitter
turns off.
6.8 S witch the transmitter of f
NOTE: When the transmitter is switched off, it remains logged in to the receiver(s).
To logout, see
"6.7 Log the transmitter out from a receiver"
When the transmitter is active and the stop button is pressed, all relays on the
receiver deactivate.
1. Press the
Stop
button.
The display shows:
[Stopping]
.
The transmitter turns off. All relays on the receiver deactivate.
1
T9
: button 5;
T11
: button 9.
26
ED-TG2-TX102-EN-v02
