End user instructions
│
T9/T11
│
Chapter 6: Operation
6.6 S tart a session (PIN code requ ired)
To be able to control a receiver with the transmitter, the transmitter must be
registered in the receiver
. If no receiver is registered, the display will show
[No
receivers][Press Menu + Stop]
after the stop button has been pulled out.
When not in use, transmitters must be switched off and stored in a
secure storage space.
Do not use the system if the stop button is damaged or if it does not
stop the equipment. Doing so could result in serious injury or death.
NOTE: If no action is taken within 3 minutes after the
Stop
button has been
released, the transmitter will turn off. Press the
Stop
button before making a new
attempt to start the transmitter.
NOTE: The last accessed receiver(s) will automatically be selected the next time
the transmitter is started.
1. Make sure that the
Stop
button is pressed.
2. Twist and release the
Stop
button.
The top LED lights. The display shows:
[Enter PIN]
.
3. Enter the PIN code (4 digits). Use the buttons according to the following
table.
Digit
T9 models
T11 models
1
Button 1
Button 1
2
Button 2
Button 2
3
Button 3
Button 3
4
Button 4
Button 4
5
–
Button 5
6
–
Button 6
7
–
Button 7
8
–
Button 8
T9:
The display shows:
[Start by pressing 5+6]
;
T11:
The display shows:
[Start by pressing 9+10]
.
24
ED-TG2-TX102-EN-v02
