End user instructions
│
T9/T11
│
Chapter 6: Operation
Go to step 5 to log in to the previously selected receiver, go to next step to
select another receiver.
If no receiver is selected, the red LEDs for all available receivers will flash.
The display will show
[Select receiver(s)]
.
4. Press the button(s) corresponding to the receiver(s) to operate.
The respective red LEDs stop flashing and remain lit.
T9:
The display shows:
[Start by pressing 5+6]
;
T11:
The display shows:
[Start by pressing
9+10]
To cancel, press the same button again.
5. Press and hold both
Start
buttons simultaneously.
The buzzer emits a beep.
6. Release both
Start
buttons.
The buzzer stops beeping. The top LED flashes.
The display shows:
[Logging
in]
.
When a radio link has been established, the top LED stops flashing and
remains lit, the selected receivers red LEDs go out and the stop relays
activate.
7. Proceed with the functional test (see
).
If no radio link is established within 25 seconds, the transmitter will turn off. Go
back to step 1 and try again.
ED-TG2-TX102-EN-v02
25
