Telair Energy 4010D, Руководство по эксплуатации и обслуживанию

Страница: 11 / 44

Vers. 002
Energy 4010 D
GB
11
4.6 Auxiliary battery charger connection
It is possible to connect a battery other than the
one connected to the generator through the 2-pin
connector (fig. 15 ref. 3), on which there is an
alternated voltage of 12 V 50 Hz, max current 5
A; this can be done by installing a charge
regulator RCB (optional, item code 05424)
between this connector and the battery.
Do not directly connect
any battery to this connector!
5 Electric connections
5.1 Preparing the Wiring connection
By using the special key to open the lock,
remove the front door (fig. 16 ref. 3).
Then remove the bottom surface locking screw
(fig. 16 ref. 1) on both sides.
Take out the bottom surface with the engine all
the way to the mechanical stop (fig. 17).
If you wish to completely remove the engine
surface, screw out the setscrews (fig. 16 ref. 2)
too.
5.2 230 VAC wiring connection
To connect loads to the power generating set,
use a three-pole cable up to the applicable
standards in force. The correct cross section is
shown in
Table 1.
For connection to the 230V input line, the
generating set is equipped with a special terminal
strip (fig. 18 ref. 2) to which the cables must be
connected.
Make sure the rubber fairlead is well positioned
to prevent water seepage
Even if the generating set is provided with a
thermoswitch to disconnect power supply (fig. 18
ref. 1) in case of overload or short-circuit, a
suitably calibrated circuit breaker should be
installed inside the switchboard of the vehicle,
which disconnects the power line to users
whenever power input exceeds
15 A.
If the thermoswith of the generating set has been
operated, press the button (fig. 18 ref. 1) to
restore closed circuit and power delivery
conditions.