Tektronix TDS 510A, Инструкция по эксплуатации

Страница: 58 / 116

Performance Tests
1–44
TDS 510A Performance Verification and Specifications
CHECK that the Lower Limit readout, after the oscilloscope stops
triggering, is within 1
m
s to 3
m
s, inclusive.
Enter time on test record.
Use the keypad to return the Lower Limit to 500 ns and reestablish
triggering.
Press the side-menu button Upper Limit; then use the general
purpose knob to slowly decrease the Upper Limit readout until
triggering stops.
CHECK that the Upper Limit readout, after the oscilloscope loses
triggering, is within 1
m
s to 3
m
s, inclusive.
Enter the time on test record.
4. Disconnect the hookup: Disconnect the cable from the generator output at
the input connector of CH 1.
Equipment
Required One DC calibration generator (Item 9)
One BNC T connector (Item 7)
Two 50
W,
precision coaxial cables (Item 5)
Prerequisites See page 1–15.
DC Calibrator
50
W
Coaxial Cables
Dual Banana to
BNC Adapters
BNC T
Connector
Digitizing Oscilloscope
Figure 1–15: Initial Test Hookup
1. Install the test hookup and preset the instrument controls:
a. Hook up the test-signal source:
Set the output of the DC calibration generator to 0 volts.
Check Accuracy,
Trigger-Level or
Threshold, DC Coupled