Tektronix TCPA300 SERIES, Инструкция по эксплуатации

Страница: 130 / 205

TCP303 and TCP404XL Performance Verification
5- 40
TCPA300/400 Amplifiers and TCP300/400 Series Current Probes Instruction Manual
Make or verify the equipment settings in Table 5--21.
Table 5- 21: Equipment settings for bandwidth
Oscilloscope
Vertical input impedance 50
Ω
Time base 200 ns/division
Record length 500
Coupling DC
Offset 0 V (mid-scale)
Trigger type Edge
Trigger mode Auto
Trigger position 50%
Acquisition mode Average
Number of waveforms to average 8
Measurement type Peak-to-Peak
Leveled sine wave generator
Frequency 3 MHz
Amplitude 3 V
p-p
TCPA300
Coupling DC
Range 5 A/V
1.
Do not clamp the current probe around any conductor, but make sure the
jaws are locked shut.
2. Press the amplifier PROBE DEGAUSS AUTOBALANCE button. Wait for
the degauss/autobalance routine to complete before proceeding. The routine
is complete when the indicator light turns green.
3. Clamp the current probe around the HF current loop.
4.
Enable the output of the leveled sinewave generator.
5. Verify the output level is what is listed for the probe in Table 5--22.
6. Using the peak-peak measurement capability of the oscilloscope, measure
and record the peak-peak reading as
M
1
in Table 5--22 on page 5--41 .
7. Set the oscilloscope time base to 40 or 50 ns/division. Increase the signal
generator frequency to the warranted bandwidth. Refer to the test record for
the warranted bandwidth.
8. Using the peak-peak measurement capability of the oscilloscope, measure
and record the peak-peak reading as
M
2
.
Equipment Settings
Procedure