4-18
Section 4 — Maintenance
Install Assembly in Frame
1.
To install the replacement supply in the frame, slide it into place from the front
of the frame, secure it with the two screws previously removed, and close the
front door.
2.
Disconnect the wide connector from the circuit board. (It’s still connected in
the Todd frame, even though you removed it in the Pioneer frame.)
3.
At the terminal block you just installed on the Todd power unit, connect the
blue and brown AC power wires you previously disconnected from the
Pioneer supply, as shown in
. (These may be reached and pushed
back into the power supply area from the front of the frame if necessary.)
4.
Connect the blue wire coming out of the frame to the terminal with the blue
jumper wire; connect the brown wire coming out of the frame to the terminal
with the brown jumper wire.
Connect
2 Connectors
to
Signal Processor
or Upper
Power Supply
Connect
Multi-Wire
Connector
to
Circuit Board
Connect
Blue Wire
Connect
Brown Wire
2405-02
Figure 4-7. Installation of Todd Multi-Output Power Supply Assembly
Содержание Grass Valley 4000
