2-81
Cable Connections
NOTE:
Standard length of the RS-422 cable is 16 meters (The cable length is indicated by
the dash number on the end of the part number.) The maximum combined length of the
adapter and RS-422 cables should not exceed 300 meters.
The adapter cable connects between J17 at the rear of the Kaleidoscope Controller
chassis, and the 9-pin D-type connector on the end of the RS-422 control cable. The
control cable connects to J1 (Port A1) or J3 (Port A2) on the Communications Panel
at the rear of the Model 4000 Signal Processor Frame.
NOTE:
This interface requires that the Serial Communications mezzanine board (068918)
be installed on the Model 4000 Expanded Communications Carrier Module (064824). The
Expanded Communications Carrier Module is located in slot C1 in the Model 4000 Signal
Processor Frame.
Additional Kaleidoscope requirements are as follows: The Parallel I/O module in the
Kaleidoscope Controller must be a 068604 module (not a 068537), and the software version
installed in Kaleidoscope must be 6.0 or later.
Connecting to a DPM–700
The Model 4000 can initiate E-MEM Effects Memory Learn and Recall operations
in a DPM-700 using Peripheral Bus II protocol. In addition, the Model 4000 can
trigger specific functions in the DPM.
Communication is controlled from the Model 4000 to the DPM; the DPM will not
control or communicate with the Model 4000. (Direct DPM control of the Model
4000 Aux buses is not provided.)
NOTE:
This interface requires that the Serial Communications mezzanine board (068918)
be installed on the Model 4000 Expanded Communication Module (068824). The
Expanded Communications Module is located in slot C1 in the C Bay of the Model 4000
Signal Processor Frame.
Control and video/key connections between the Model 4000 and the DPM are
illustrated in
. The Model 4000’s Aux Bus video and key outputs are
connected to the DPM’s Channel 1 and Channel 2 inputs, as shown (2nd. channel
DPM optional). The DPM’s outputs can be connected to any of the Model 4000’s
physical inputs. The inputs are then assigned via menus to any crosspoints, as
described later in this section (Map Inputs Menu under Inputs Menu).
Содержание Grass Valley 4000
