Tektronix DPO7054, Руководство пользователя

Страница: 178 / 213

Run Application Software
Run Application Software
Each application is available for ten free trials on your instrument. These applications provide application-specific
measurement solutions. Some examples are described below. Additional packages may be available. Some applications
may not be available on your instrument. Contact your Tektronix representative or visit our Web site at www.tektronix.com
for more information.
Use ASM Advanced Event Search and Mark to examine data by highlighting important events and skipping the
unimportant events.
Use DDRA Memory Bus Analysis to automatically identify DDR1, LP-DDR1, DDR2, DDR3 and GDDR3 read and writes.
Use DJA Jitter and Eye Diagram Analysis, Advanced to reliably measure complex clock, digital, and serial data signals.
Use DSPT Display Port Compliance Software to validate your IC, motherboard, and graphics card designs.
Use DVI Compliance Test Solution Software for DVI physical layer compliance testing.
Use ET3 to perform 10/100/1000 Base-T Ethernet compliance testing.
Use FBD RTE module for FB-DIMM compliance for ≥ 4 GHz models.
Use HT3 HDMI Compliance Test Software for HDMI compliance testing for ≥ 4 GHz models.
Use IBA RTE module for InfiniBand for ≥ 4 GHz models.
Use J2 Disk Drive Measurement Software to measure disk drive signals according to IDEMA standards.
Use JA3 Advanced Jitter Analysis Software to characterize timing performance. Analyze jitter on contiguous clock
cycles using single-shot acquisitions.
Use LSA Serial Analysis Software for CAN/LIN protocol triggering and analysis.
Use LT Waveform Limit Testing to compare an acquired waveform to tolerance boundaries that you set.
Use MTH Communication Mask Testing Software for mask compliance testing on ≥ 4 GHz models.
Use MTM Communication Mask Testing Software for mask compliance testing on <4 GHz models.
Use PCE RTE module for PCI-Express for ≥ 4 GHz models.
Use PS1 Power Solution Bundle to measure and analyze power supplies.
Use PTH , PTU or STU Serial Protocol Trigger Software to trigger and decode 8 B/10 B data on high-speed serial
or data protocols. Protocol triggering up to 6.25 GS/s.
Use PTM and PTD Serial Protocol Trigger and Decode Software to simplify validation of and isolate data dependent
faults at data rates up to 1.25 Gb/s.
Use PWR Power Measurement Software to quickly measure and analyze power dissipation in power supply switching
devices and magnetic components.
Use SLA and SLE Serial Data Link Analysis to emulate the serial data channel, de-embed a fixture, and add or remove
transmitter equalization. SLA adds processing of waveforms with equalizations.
Use SR-COMP to enable serial triggering and analysis of RS-232/422/485/UART signals.
Use SR-EMBD to enable serial triggering and analysis of I2C and SPI signals.
Use SR-USB to enable serial triggering and analysis of LS, FS, and HS USB signals.
Use SST Serial ATA and Serial Attached SCSI compliance module with option RTE.
MSO70000/C, DPO/DSA70000B/C, DPO7000, and MSO/DPO5000 Series User Manual 157