Tektronix 1730 Series, Инструкция по эксплуатации

Страница: 163 / 258

1730–Series Maintenance
6–3
Table 6–1: (Cont.)Static Susceptibility
Relative Susceptibility Levels Voltage
LOW POWER SCHOTT-
KY TTL
TTL
Observe the following precautions to avoid damage:
1. Minimize handling of static–sensitive components.
2. Transport and store static–sensitive components or assemblies in their
original containers, on a metal rail, or on conductive foam. Label any
package that contains static–sensitive components or assemblies.
3. Discharge the static voltage from your body, by wearing a wrist
grounding strap, while handling these components. Servicing static–sensi-
tive assemblies or components should be done only at a static–free work
station by qualified personnel.
4. Nothing capable of generating or holding a static charge should be
allowed on the work station surface.
5. Keep the component leads shorted together whenever possible.
6. Pick up the components by the body, never by the leads.
7. Do not slide the components over any surface.
8. Avoid handling components in areas that have a floor or work surface
covering capable of generating a static charge.
9. Use a soldering iron that is connected to earth ground.
10. Use only special antistatic, suction, or wick–type desoldering tools.
Instrument performance should be checked after each 2000 hours of operation, or
every 12 months, if used intermittently. This will help to ensure maximum
performance and assist in locating defects that may not be apparent during
regular operation. The Performance Check Procedure and the Adjustment
Procedure are in Section 5.
Troubleshooting
The material contained here is general and is not intended to cover specific cases.
Performance Checks and
Readjustments