LoRa IoT Industrial Tracker User Guide
T0006279_UG
Version 1.1
TEKTELIC Communications Inc.
Confidential
Page 10 of 17
2
Installation
2.1
Included Product and Installation Material
The following items are shipped with each tracker:
•
LoRa IoT Industrial Tracker in a ruggedized IP67 polycarbonate enclosure with D-cell LTC
batteries installed
•
Magnet to wake up the Tracker from deep sleep
2.2
Safety Precautions
The following safety precautions should be observed:
•
Use only LTC cells.
•
Should the Tracker be opened and powered externally, do not exceed the maximum specified
terminal voltages.
•
All installation practices must be in accordance with the local and national electrical codes.
2.3
Unpacking and Inspection
The following should be considered during the unpacking of a new Industrial Tracker:
•
Inspect the shipping carton and report any significant damage to TEKTELIC.
•
Unpacking should be conducted in a clean and dry location.
•
Do not discard the shipping box or inserts as they will be required if a unit is returned for repair
or re-configuration.
2.4
Commissioning and Awakening
The Tracker is shipped in closed enclosure with the batteries installed and engaged. However, the
Tracker is in a state of DEEP SLEEP where it draws
infinitesimal
current, until it is woken up by the
provided magnet
1
.
The Tracker does not need to get opened to be awakened. Assuming that the Tracker has been
commissioned on the NS, use the magnet to wake up the Tracker as illustrated in Figure 2-1. The
wake-up pattern has a 3-1 or PAP-P code. The magnet sign can be seen at the bottom of the
enclosure. As soon as the specified magnetic pattern is applied to the Tracker, the Tracker is reset and
tries to join the network. See section 4.3 for the expected LED behaviour of the Tracker during the
join process.
1
Any magnet as strong as, or stronger than, Standex-Meder M4, M5, or M13 can be used as well.
