| RENT: OPALED |
| OPALED |
via GIUSEPPE DI VITTORIO 9
20037 PADERNO DUGNANO (MI) ITALY
CONTACT US: (+39) 0291082905 - WWW.TEKSET.IT
via NAZARIO SAURO 13/A
20037 PADERNO DUGNANO (MI) ITALY
CONTACT US: (+39) 0291082905 - WWW.TEKSETRENTAL.IT
TekSet
Rental S.r.l.
RGB DMX POWER SUPPLY
Version 6.0
18
www.mbnled.com
PROGRAM 9
Step 1/3: Red + Green 100% with fade to
Step 2/3: Green + Blue 100% with fade to
Step 3/3: Blue + Red 100% with fade to Step1
PROGRAM 10
Step 1/1: Red + Green + Blue 100%
SPEED ADJUSTMENT SETUP MENU
With the UP and DOWN buttons you can access the speed adjustment menu. After
pressing the ENTER button you can select the speed with the UP and DOWN
buttons. By adjusting this value you can select the speed of the running program.
There are 255 different speeds selectable. Speed 0 means, that the program stops,
speed 1 is the slowest speed and speed 255 is the fastest speed. Press the ENTER
button to confirm the adjusted speed. The selected program will now always run with
the speed entered here.
MENU MODE SETUP MENU
With the UP and DOWN buttons you can access the setup mode. After pressing the
ENTER button you can select a sub-menu item with the UP and DOWN buttons.
In setup mode you can adjust and modify lots of parameters.
SETUP MENU ITEMS
Minimum channel intensity adjustment (0-39%)
Maximum channel intensity adjustment (49-100%)
Default channel intensity adjustment (0-100%)
RGB DMX POWER SUPPLY
Version 6.0
19
www.mbnled.com
Swap DMX channel intensity (a high DMX value effects low light intensity, a low DMX
value effects high light intensity)
Switch master mode on and off
Display adjustment (contrast 10-100%)
Range adjustment (display channel intensity either as 0-100 % or as 0-255 bit value)
Display operating time (0-9999 hours)
Reset, restore factory settings
Display software version number
SETUP MENU MODE MINIMUM LEVEL
Here you can adjust the minimum values. Channel outputs can not drop below the
adjusted minimum level. Press the ENTER button and select one of the three
channels (R G B) with the UP and DOWN buttons. After pressing the ENTER button
again you can adjust the selected channel minimum value.
