MAINBOARD BIOS SETUP
MAINBOARD BIOS SETUP
P6L40-A4E
P6L40-A4E User’s Manual
User’s Manual
33
33
Soft-Off by PWR-BTTN
- With
Instant-Off
selected, the ATX switch functions like a
normal system power off button. With
Delay 4 Sec.
selected, you must hold down the ATX
switch for more than 4 seconds to power off the system.
PWRON After PWR-Fail
– This feature will power-on the PC when power returns after a
power failure. The table on the next page lists the options available and the corresponding
“System State” when power returns.
Options Available
System State When
System State When
Failure Occurred
Returns
Former-Sts
On
On
Off
Off
Off
On
Off
Off
Off
On
On
On
Off
On
Resume by Ring/LAN
–
With a modem installed, this item enables the modem to power on
the system or return it to full power out of suspend / standby mode. With a LAN card
installed, the Wake-up On LAN function allows the network to wake up a Soft Power Down
(Soft-Off) PC. Refer to “Wake-up On LAN Connector” on page 16 for more information.
Resume by Alarm
-
When enabled, the system will automatically power on or returns to
full power out of suspend/standby mode at the time and date of the month (0 for daily)
specified.
IRQ 8 Break Suspend
-
When
IRQ 8 Clock Event
is enabled, the unmasked IRQ8 will
generate a Fast Burst Timer reload or stop break event.
** Reload Global Timer Events **
IRQ[3-7, 9-15], NMI: Enable an unmasked IRQ [3-7, 9-15], NMI, when asserted, reload the
Global Standby Timer.
Primary/Secondary IDE 0/1, Floppy Disk, Serial Port, Parallel Port: Enable reload events
from the respective device monitor to reload the Global Standby Timer.
PNP/PCI Configuration Setup
The PCI
P
ersonal
C
omponent
I
nterconnect Bus was developed by Intel and other industry
leader partners primarily to address two important issues faced by PC hardware designers
today: a) How to allow peripheral devices to take the fullest advantage of the power of
Pentium and Pentium Pro chip technology, and b) Provide a simpler installation process for
peripheral devices, such as Network cards, EIDE or SCSI controllers.
