teko Atra-814 Pro, Руководство по эксплуатации

Страница: 19 / 36

19
The following statuses are used for viewing:
«
S
» - alerting stopped
«
D
» - delay before alerting start
«
A
» - alerting is ON.
ATTENTION!
According to requirements, a minimum time delay for starting alerting makes
30 seconds. This time is intended for cancellation of alerting, when obvious
false response is detected. In practice, applied time delay makes minimum 1
minute.
When cancelling alerting, you should take into account additional time,
required for exchange of information between the keypad and the central CP
during authorization, selecting a menu item and sending a cancellation
command. This time makes on average about 15 seconds and must be
considered when you set up time of delay.
7.3.3
The menu item «
4. Failures
» enables to view failures using filters for your
convenience:
«
1. By part. number
» – failures, service required and sabotage.
«
2.Sabotage
» – tampering and detachment from mounting
surface.
«
3.Failures
» – all critical failures excluding tampering and
detachment.
«
4.Service required
» – non-critical failures, which require maintenance of
the devices
, but not leading to “not ready” statuses
of the partitions (e.g. reduction of main power
supply).
If you select the filter «
1. By part. number
», the information will be displayed as
described in 7.2.3 .
Activation of the filter «
2.Sabotage
» results in display of a list, which browsing by
pressing
▼, ▲ will lead to succession of view screens:
When you select the fil
ters «
3.Failures
» and «
4. Service required
» the information
will be displayed as in «
2.Sabotage
».
IP 0004
tampering