teko Atra-814 Pro, Руководство по эксплуатации

Страница: 17 / 36

17
A full list of possible operations:
1. Arm
2. Arm with bypass
3. Disarm
4. Re-arm
Your choice is to be confirmed by pressing
ОК
, thereafter the keypad will send a
command to CP, which will be executed and confirmed or not confirmed in view
screens:
Execution may be rejected in case of sending a command, conflicting with the status of a
partition, e.g. you try to arm a partition, which is not ready.
The command «
2. Arm with bypass
» (equivalent is
PIN code with additional # in
case of direct control, see 5.1 ) enables to ignore causes if it is allowed by settings of
the partition. If conditions of bypass are executed, the partition, which is not ready to
be armed will be armed with the following notification
After the notification appears, by pressing # you may see detailed conditions of
arming as view screens, which may be browsed by pressing
▼, ▲:
Here:
«
HE
» – type of device sending information, which confers the status
“not ready” to the partition
«0003/1 » – ES address (0003 – number in the list of hardwired (or wireless)
units, 1
– number of the device detection channel; in the given
example AL № 1 of hardwired receiver)
« Р:007 » – partition number
«
[bypass]
» – operation
«
failure
» – event type.
Attention!
Arming with bypass results in partial loss of control over the protected
facilities and it is not recommended to use it as a constant remedy!
Not completed Done
Part. control
Р007 Armed #
HE 0003/1
Р:007
[bypass] failure
1. Взять