Teknoware TAPSA CONTROL TKT65, Инструкция по установке и обслуживанию

Страница: 13 / 53

VOT 34; Rev 1.81; EN; 11.12.2019
TKT65C
– Installation and maintenance
13
If the battery is disconnected, the
charger doesn’t charge, the battery
fuse is blown or the battery doesn’t
accept charging current, the
following alarms are displayed on
the panel:

Mains operation LED

Battery undervoltage or
overvoltage LED

Battery fault LED

Internal fault LED
Refer to the instructions given for the LED that
specifies the battery fault (Battery overvoltage,
Battery undervoltage and Deep discharge).
To reset the possible battery fault alarm, press the
Reset / Test button.
9 EARTH
LEAKAGE Possible earth leakage inside the
central battery unit.
Not in use.
10 INTERNAL
FAULT
This LED alarms when some
internal fault of the central battery
unit is detected, a fault in the battery
or the charging circuit.
This LED can be lit with other LEDs
that indicate the fault more
specifically.
This LED is also lit when the
batteries are being changed.
Refer to the instructions given for the LED that
specifies the battery fault.
4.8
Control Module panel luminaire monitoring LEDs and menu settings
LED Description Instruction
Number display
Shows the number of the circuit whose
luminaires are shown with LEDs 1-16.
If “CC” is flashing on the display, the system
has not been configured.
For configuring the system, see
chapter
0 Configuration.