Teknoware TAPSA CONTROL TKT65, Инструкция по установке и обслуживанию

Страница: 20 / 53

VOT 34; Rev 1.81; EN; 11.12.2019
TKT65C
– Installation and maintenance
20
or
1. Press the MENU / OK button.
2. Use the BROWSE button to
select 2, TESTING.
3. Use the SET button to select 1 =
Starting the luminaire test.
4. Accept the selection with the
MENU / OK button.
The luminaire test starts. If a faulty
luminaire was found in any of the
circuits, its corresponding LED will
flash when its circuit number is
shown on the display.
If luminaire test will not start, check
battery voltage level. It must be
more than
200 VDC.
LOCAL CONTR.
ALARM
The central battery unit can be remote
controlled to send a local controller pulse to all
circuits, in which case all the non-maintained
addressable luminaires (Teknoware types
ending with
–K, or external luminaires fitted
with Teknoware address module) that are
connected to the central battery unit are
switched on. This feature can be activated by
opening loop 13-14.

If the LED is lit, the loop 13-14 is open.

If the LED is blinking slowly, K-model
luminaires are turned on from the menu
with AC voltage.
.
Check the loop between connectors
13-14.
FUSE FAULT

If the LED is lit, there is a faulty fuse in the
control module.

If the LED is blinking slowly, there is a
faulty fuse in the circuit shown on the
display.

If the LED is blinking quickly, there is
some other fault in the circuit shown on
the display.
Check all circuit output fuses.
EXTERNAL FAULT
Alarms when an external fault is detected in
the battery or the luminaire, the battery or the
luminaire test has failed.
If the LED is flashing with
Luminaire test LED,
configuration is in progress.
Check that all luminaires are
working.