117-0815-0027
jaw segment to make sure the ring is properly seated in jaw slide groove.
Check for a gap between jaw slide and Cole Jaw segment
– there should be
no light showing.IT SHOULD NOT BE RIDING UP ON THE EDGE OF THE
GROOVE!
4. Screws should first be wound down until heads just touch the jaws.
5. Starting with the inside screw, wind it ¼ to ½ a turn. Similarly wind outside
screws until screws are fully home. DO NOT OVERTIGHTEN.
6. Repeat procedure on all four segments.
Note:
The four Cole Jaw die cast segments provided are all identical, so they can be
mounted in any sequence. Hence they are not numbered. It may be convenient to
number them 1-4 in clockwise sequence when mounted on the chuck so that they
can be put back in the same sequence each time. The standard mounting screws
that come with the Teknatool chucks can be used for this purpose. Extra screws can
be obtained by purchasing the “Nova Fastening Spares Kit”.
Check there is no light between jaw slides and add on jaw segments or that one or
more segments is not higher or lower than the others. If this is the case, repeat the
procedure as above.
