117-0815-0025
ALWAYS WEAR EYE PROTECTION WHICH COMPLIES WITH CURRENT ANSI
STANDARD Z87.1 (USA). WE STRONGLY RECOMMEND THAT A FULL FACE SHIELD IS
USED AT ALL TIMES.
BEFORE USING THE TEKNATOOL CHUCK ACCESSORY JAWS BE SURE THAT:
WARNING!!! EXCESSIVE SPEED IS A SERIOUS LATHE HAZARD. ALWAYS
TURN AT THE LOWEST SPEED POSSIBLE.
Speed required will vary with wood
blank size. The larger the blank the slower the speed. Consult your lathe manual.
DO NOT ATTEMPT TO USE THE CHUCK UNLESS THE LATHE SPEEDS ARE
KNOWN. YOU MUST STRICTLY FOLLOW THE MAXIMUM SPEED LIMITS SET
OUT IN THE OPERATIONAL SECTIONS OF THIS MANUAL. DO NOT EXCEED
THEM UNDER ANY CIRCUMSTANCES.
EXAMINE WOOD CAREFULLY. ONLY MOUNT SOUND WOOD. If any cracks or
weakness is found in the wood
– DO NOT MOUNT IN CHUCK OR IN ACCESSORY
JAWS. DO NOT MOUNT WOOD THAT IS LIKELY TO BREAK UP DURING
TURNING (E.G. ROTTEN OR SPONGY WOOD). DO NOT USE POORLY
LAMINATED WOOD.
DO NOT EXCEED MAXIMUM GUIDELINES IN THIS MANUAL FOR WOOD BLANK
DIAMETER / LENGTH FOR THE DIFFERENT MODES OF OPERATION AND JAW
TYPES.
DO NOT EXTEND JAW SLIDES BEYOND CHUCK BODY UNDER ANY
CIRCUMSTANCES. ONLY OPERATE CHUCK WITH JAW SLIDE STOP SCREW IN
PLACE. This prevents jaw slides from dislodging from chuck. NOTE: SuperNova2
Chuck has automatic internal stop.
WARNING - MAKE SURE THAT IN EXPANSION MODE THAT THE AMOUNT OF
TRAVEL REQUIRED IS LESS THAN THE LIMIT OF THE STOP SCREW, OR
AUTOSTOP. DO NOT TRY TO FORCE CHUCK OPEN FURTHER.
ALWAYS TEST WORKPIECE IS GRIPPED SECURELY IN THE JAWS. BEFORE
OPERATION TEST BY WRENCHING WORKPIECE IN JAWS. IF ANY LOOSENING
OCCURS, RE-EXAMINE HOLDING AREA FOR ADEQUATE GRIP (following
mounting guidelines) AND ANY DAMAGE TO GRIPPING AREA.
MAKE SURE WORKPIECE IS CLEAR OF OBSTRUCTION BY MANUALLY
ROTATING WORKPIECE BEFORE SWITCHING POWER ON.
