IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
RELEASE DATE
8-14-17
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • [email protected]
REFERENCE NUMBER
INS-2615-00
LIBERTY FLOODLIGHT™ (LBF)
5. Gently lift LED module and disconnect from
fixture. Install new LED module. Secure set
screws through LED module and optic holder
using .050” Allen wrench.
Do not pull on connector or wiring. Handle
with care.
3. Remove optic by pulling gently and lift up.
4. Use .050” Allen wrench to loosen three (3) set
screws holding optic holder and LED module.
6. Replace optic by lining tabs with optic holder, then
pressing down gently until secured into place.
This product is available with field replaceable components. Exclusive interchangeable OPTIKITS and modular
LED components with quick disconnects simplifies upgrades and maintenance when necessary.
1.
Loosen two (2) captive screws on stainless steel
clamp rings using 5/32” Allen wrench until the
screws disengage from back plate.
2. Swing lens assembly open.
7. Close swing assembly.
8.
Tighten two (2) captive screws on stainless
steel clamp rings using 5/32” Allen wrench. Do
not overtighten.