Junction Box Remote Driver Installation
Finished grade
Pea gravel or sand
Concrete or Dirt
Finished grade
3. Slide Stability Flange onto Power Pipe™. Use
Stability Flange to aid in installation of Power
Pipe™.
2. Excavate trench according to designed lighting
plan. Dig hole a minimum of 24” deep and 10”
wide to accommodate Power Pipe™ at desired
fixture locations.
1. Determine Soil Type by referencing DIG-IT Guide.
Prep soil according to DIG-IT Guide.
9. Insert wires and connectors into Power Pipe™.
Place fixture on Power Pipe™.
10. Tighten three (3) #10-32 set screws using Phillips
screwdriver.
8. Make waterproof connections from remote
driver to fixture leads using supplied waterproof
wire connectors.
See wiring diagram.
Finished grade
Pea gravel or sand
Concrete or Dirt
Finished grade
4. Pull secondary wiring from remote driver to
Power Pipe™. Allow for additional cable to make
connections to fixture lead, future service and
stem length adjustment. Place Power Pipe™ in
hole.
Finished grade
Pea gravel or sand
Concrete or Dirt
Finished grade
6. Back fill with pea gravel or sand prior to pour.
Finished grade
Pea gravel or sand
Concrete or Dirt
Finished grade
7. Pour concrete (By Others).
Label on Power Pipe™ indicates installation
depth with finished grade.
5. Connect conduit to the conduit couplers
attached to the bottom of the Power Pipe™.
Place Power Pipe™ in hole.
Finished grade
Pea gravel or sand
Concrete or Dirt
Finished grade
RELEASE DATE
9-13-17
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF TEKA ILLUMINATION AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL ANYTHING
IT MAY DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF TEKA ILLUMINATION IS STRICTLY FORBIDDEN.
DRAWING
NUMBER
INS-2656-01
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
POWER PIPE II™ SYSTEM
Installation
Failure to use waterproof wire connectors
will cause fixture to fail and VOID PRODUCT
WARRANTY.
WIRING DIAGRAM
LINE
+
LED
COM
Remote
Driver
-
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • [email protected]