10 TEGAM WAY • GENEVA, OHIO 44041 • 440-466-6100 • FAX 440-466-6110
•
2-2
PREPARATION FOR USE AND INSTALLATION
of the fuse holder (the side with the metal jumper), and
the dual 5x20mm fuses get installed on the other side.
c.
Pull the voltage selector card from its slot at the bottom
end of the mains entry module and reposition the plastic
indicator for the required mains voltage (120 or 240).
d.
Insert the voltage selector card back into its slot such that
the plastic indicator is at the top of the module assembly.
e.
Close the door and note that the indicator pin now
indicates the correct mains voltage. If it is not indicated
properly, then remove as in points a to d and ensure that
the proper voltage is selected.
Battery Installation
Remove the ten screws around the outside edge of the
panel, which secure the instrument to the case. The
instrument may now be lifted out of the case by holding the
binding posts.
WARNING
DO NOT CONNECT THE AC LINE CORD PRIOR TO
REMOVING THE UNIT FROM ITS CASE OR WHILE THE UNIT
IS OUT OF ITS CASE, OR ELSE THE MAINS VOLTAGE WILL
PRESENT A POSSIBLE SHOCK HAZARD.
CAUTION
DO NOT OPERATE THIS INSTRUMENT WITHOUT ITS
INTERNAL BATTERY.
Remove the four screws holding the battery cover to its
mounting spacers and install the five C-cells in their holder
at the bottom of the instrument; be sure to install them
with the correct polarity, as marked on the holder. While
installing the cells, rotate them lightly to ensure connection
to the holder contacts.
After installing the cells, reinstall the battery cover with its
four screws, and reinstall the instrument in its case and
secure the ten mounting screws.
